CrimeStopper CS-2000.III Operations Instructions

CS-2000 Series III REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of an

OPTION PROGRAMMING 8. SILENT ARMING /DISARMING (CHIRP DEFEAT) With this feature, the system can be programmed to Arm and Disarm without the siren chi

OPERATING INSTRUCTIONS ACTIVE ARMING To arm the alarm and lock the doors, press the #1 Button (Lock/Unlock Symbol) on the transmitter. You will hear

OPERATING INSTRUCTIONS SILENT ARM/DISARM THROUGH REMOTE (BUTTON #2) This system can be armed and disarmed without siren chirps on an “as needed” basi

OPERATING INSTRUCTIONS PASSIVE ARMING / PASSIVE LOCK MODES / PASSIVE CHIRP COUNTDOWN If programmed, passive (Automatic) Arming will occur 30 Seconds

CARJACK PROTECTION ACTIVE CARJACK This feature provides Active Carjack protection and must be enabled before use through Alarm programming option (14

+-+REDWHITEBROWNBLUE/WHITEWHITE/REDORANGEBLACK/WHITEBLUEGRAYYELLOWBLACKVIOLETGREENLEDOVERRIDE/PROGRAMBUTTONBATTERY(-) LOCK OUTPUT+12 VOLT FOR RELAYS(-

ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb03.html [email protected] Phone (

TABLE OF CONTENTS Installation Cautions & Warnings…….………………………………………………………….………………2 Control Module & Component Mounting…………….………………………..………

CONTROL MODULE MOUNTING DO NOT Mount the control unit in the engine compartment! DO NOT Mount the control unit or wiring harness where they can beco

WIRING GREEN WIRE: (-) DOOR TRIGGER Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles

WIRING BROWN/WHITE WIRE: (-) HORN PULSE / CHIRP OUTPUT (Optional, may require a relay) Connect to the Negative Horn Trigger wire usually located near

POWER DOOR LOCK WIRING 3 PIN DOOR LOCK PLUG (Optional): GREEN: (-) Negative LOCK Pulse, RED: +12V Coil Power for relays, BLUE: (-) Negative UNLOCK

REMOTE TRANSMITTER PROGRAMMING 1. Turn Ignition ON. 2. Press the Program/Override Button 4 times. After a few second delay, the lights should flas

OPTION PROGRAMMING 1. Turn the Ignition ON and press the Override/Program button 5 times. After a slight delay, the system will flash the lights 5

OPTION PROGRAMMING 1. HORN CHIRPS / PULSES This option controls the system’s Horn-honk output. There are 3 selections: Button 1 (Lock) = Horn Pulse