CrimeStopper CS-2011RS.II User Manual download pdf (Page 12)

TRANSMITTER PROGRAMMING

Note: All transmitter codes must be learned at time of programming!! The CS2011RS allows storage

of up to 4 different transmitter codes.

1. Open Hood. (Blue wire grounded.)

2. Turn key to the ON position. (Doors will lock if Autolock is programmed)

3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.

4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indication the unit is waiting for a 2

code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3

code

and lights will flash 4 times for 4

code. If all 4 codes are learned, the unit will automatically exit code learning

mode, otherwise turn key off and close hood.

IGN

OFF

WAIT FOR

4 FLASHES

PRESS 4X's

FLASH 2, 3, or 4 X's

START

RIME

TOPPER

PROGRAMMABLE OPTIONS

To access programmable options:

1. Open hood (Blue wire grounded)

2. Turn Key to the ON position

3. Press program button 5 times, after a few seconds the unit will flash the lights 5 times.

4. Push the valet/program button [again] the number of times that corresponds to the option number desired. You

should get a light flash after each button press.

5. When you reach the desired programming level, Press the button on the remote that corresponds to the setting you

desire. See the chart below for option values and descriptions. See Options Chart.

6. Turn Ignition OFF, Close hood and check for changed features. Change each option individually repeating STEPS

1-5 above.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

No comments

CrimeStopper CS-2011RS.II User Manual Page 12