CrimeStopper CS-2011RS.II User Manual download pdf (Page 7)

WIRING: 5-PIN Harness (22 gauge wires)

Pink: (+12V) Diesel Glow Plug Input or Car Jack Input (Programmable Input Wire)

Glow Plug (Diesel):

Connect to the indicator circuit that shows +12 volts while the “WAIT TO START LAMP” is on. When

this wire is used, the CS2011RS will wait until light turns off before attempting a remote start. Note: An

inverter module or relay can be used for vehicles that have a Negative Wait to Start lamp circuit.

Carjack Trigger

When using Carjack protection, connect this Pink wire to a toggle switch, or positive door trigger or

ignition depending on your level of Carjack protection. When +12V is applied to this wire with IGN on

and a door is opened then closed, a Carjack countdown will begin. See Diagram Below for optional

wiring configurations.

12 V

PINK

OPTIONAL CAR JACK WIRING:

HIDDEN BUTTON or

TOGGLE SWITCH

(Not Included)

IGN SW

+ IGN

CONTROLLED W/SWITCH

PINK

FULL-TIME CARJACK

White: (+12V) Brake Reset

Connect the Purple wire to the side of brake pedal switch that shows +12 volts ONLY when pedal is

depressed. This will turn off the remote start if someone attempts to drive the car without the keys or if the

Ignition key is not turned on all the way.

WIRING: 2-PIN LED / 2-PIN Program-Valet Button (22 gauge wires)

Mount LED in a visible location in the Dash or Console. Connect the small 2-pin plug from the LED to the

control module. Note: Connectors are designed so that they will only plug into their appropriate slots.

Mount the Valet/Program/Override button in a suitable location. Connect the 2-pin plug from the Switch to the

control module. Note: Connectors are designed so that they will only plug into their appropriate slots.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

CrimeStopper CS-2011RS.II User Manual Page 7