CrimeStopper RS-4 Operations Instructions Page 1

Browse online or download Operations Instructions for Remote starters CrimeStopper RS-4. CrimeStopper RS-4 Operating instructions User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
RS-3 and RS-4
1-WAY REMOTE START SYSTEM
OPERATING INSTRUCTIONS
CONGRATULATIONS on your choice of a Cool Start Remote Engine Starter and Keyless Entry with DP
Technology by Crimestopper Security Products Inc. This booklet contains the information necessary for operating
your system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Remote
Start connections, Flashing lights, and Brake Reset. For programming, the hood pin and program button are
required.
-OPTIONAL: These features are to be connected only if desired or agreed upon by the customer and the installing
dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features may also
require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is going to be
installed with your particular system.
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV B 11-2008
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
Page view 0
1 2 3 4 5 6 ... 16 17

Summary of Contents

Page 1 - RS-3 and RS-4

RS-3 and RS-4 1-WAY REMOTE START SYSTEM OPERATING INSTRUCTIONS CONGRATULATIONS on your choice of a Cool Start™ Remote Engine Starter and Keyl

Page 2 - TABLE OF CONTENTS

10 CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicl

Page 3 - 2nd Vehicle

11 CONVENIENCE AND SAFETY FEATURES VALET MODE / REMOTE START DISABLE (Requires Installation of Valet Switch) Before servicing your vehicle or handin

Page 4 - REMOTE ENGINE CONTROL

12 TRANSMITTER PROGRAMMING Note: All transmitter codes must be learned at time of programming!! The RS-4 learns up to 4 different transmitter cod

Page 5

13 VEHICLE #2Press side buttonfirst, then you have4 seconds tocontrol vehicle #2. 2-VEHICLE OPERATION & PROGRAMMING A single Remote Control can

Page 6

14 NO FACTORY KEYLESS ENTRY AFTER REMOTE START Most new cars Do Not allow the factory Remote Keyless Entry to function with the Ignition ON. This me

Page 7

15 BATTERY REPLACEMENT To replace the battery: Simply remove the 3 screws on back of the transmitter and open the case. Remove the battery and repl

Page 8

16 2-Way DATA PORT Some vehicles require a Databus Module to Bypass the factory Immobilizer and operate the keyless entry Databus modules are used

Page 9 - 1-5 TIMES

17 © 2008 Crimestopper Security Products

Page 10

2 TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………….….…………2 Using the Remote Transmitter……………………………………………………………………

Page 11

3 USING THE REMOTE TRANSMITTER SLIDE COVERUPDOWN2nd Vehicle For RS-3 The transmitter supplied with this system has 3 buttons and a car 2 side

Page 12 - TRANSMITTER PROGRAMMING

4 STATUS LED LED Operation: (Optional, requires Installation of LED) LED will flash when locking your doors with remote. LED will remain solid in V

Page 13 - VEHICLE #2

5 REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shu

Page 14 - REMOTE START DIAGNOSTICS

6 REMOTE ENGINE CONTROL IDLE DOWN MODE: This mode allows the unit to take over operation of the parked vehicle while the ignition key is removed and

Page 15 - 3 Screws

7 REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated with "Idle Down" procedure. The Infinity Run mode allows the v

Page 16 - 2-Way DATA PORT

8 TURBO TIMER MODE (OPTION #22) The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1 to

Page 17

9 SETTING THE TURBO TIMER RUN TIME REMOVE KEYPRESS TURBOFLASH 1-5XEXIT VEH.PRESSAND HOLDBRAKETIMER BUTTON1-5 TIMESRUNNINGRELEASEBRAKELIGHTSRUNNINGR

Comments to this Manuals

No comments